The (blue) Wi-Fi lamp on the printer will flash while searching for, or connecting to the access point.ģ. Make sure that the LED flashes as shown in the illustration above, then press the button on your access point within 2 minutes.įor exact details regarding pressing the WPS button, please refer to the access point manual. Make sure that the LED flashes as shown in the illustration below.Ģ. Press and hold the button (A) on the printer for approximately 5 seconds.Ģ. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.ġ. Most WPS enabled access points use this protocol.
: New firmware version 1.0.5.1 is available for EOS-C500 Mark II : New firmware version 1.0.3 is available for EOS M50 Mark II : New firmware version 1.3.2 is available for PowerShot G7 X Mark III : Service Notice:UPDATE: Canon Inkjet Printer continuous reboot loop or powering down : Service Notice: EOS 70D: Error 70 or Error 80 : New firmware version 1.3.0 is available for PowerShot PICK : New firmware version 1.0.1 is available for CR-X300 : New firmware version 1.1.0 is available for EOS-R10 : New firmware version 1.1.0 is available for EOS-R7 : New firmware version 1.6.0 is available for EOS-R6 : New firmware version 1.6.0 is available for EOS-R5 This didn't answer your question or issue? Find more help at Contact Us.
Once the drivers are downloaded and installed, please restart your computer, and you should be all set to print. Please be sure to have the USB cable unplugged from the computer prior to installing the drivers the installation program will prompt you to plug it in at the appropriate time.
The time for the download process may vary depending on the speed of your Internet connection and the size of the file being downloaded.
After clicking the "I AGREE - BEGIN DOWNLOAD" button, follow the instructions to download and install the driver. Please scroll down on the Details page and agree to the terms of the disclaimer message to continue with the download process by clicking on the "I AGREE - BEGIN DOWNLOAD" button. When you do, another page will appear giving details of the file you are about to download will appear.ģ. Next, please click on the red arrow next to the "DRIVERS" section and click the MP DRIVERS file. Verify that the operating system detected in the "OPERATING SYSTEM" drop-down menu is correct, and if it is not, please click the drop-down menu to select your operating system.Ģ. Once on the initial download page for your model, please do the following:ġ. The following link will take you to the initial download page for your PIXMA MP495: Once the wireless LAN has been enabled, we will want to download the drivers from the Canon USA website. Press the Maintenance button (looks like a pair of pliers and a screwdriver) on the printer repeatedly until the symbol that looks like "G" appears in the LCD, then press the button to enable the wireless LAN function of the printer.Ģ.
To do this, please follow the steps below:ġ. You can download and install the drivers for the printer from the Canon USA website to install the printer wirelessly.